Eaton xChargeIn Bedienungsanleitung Seite 306

Maintenance
Removing the cylinder lock
1) Turn the key to the left until the resistance is noticeably overcome.
2) Turn the key further until it is in a vertical position. The cylinder lock can
Fitting a cylinder lock
306
then be unlocked from the holder using slightly increased force and re-
moved.
1) Use a thin object to push in the coding pin to turn
the lock nose.
2) Turn the lock nose 1 so that it points vertically up-
wards in the removal position of the key.
3) Turn the key 180° so that the lock nose faces down-
ward.
4) Use light pressure to press the cylinder lock into the
housing completely until it audibly engages. The cylin-
der lock should be flush with the surface of the hous-
ing.
5) Turn the key to the right until the resistances have
been noticeably overcome and the key can be re-
moved.
Do not turn the key past the [MAX] position.
The key switch is now ready for use.
xChargeIn
Installation manual V1.05
© EATON