Insertion / Removal Of A Battery Pack Into The Appliance; Checking Battery Status; Changing Tools; Torque Pre-Selection - Parkside PABS 18 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

2. Insert the power plug into the socket. The now
glowing red charging control LED
that the charging process has begun. The red
charging control LED
as the battery pack is fully charged.
3. The green charging control LED
you that the charging process is complete and
the battery pack
½
Never charge the battery pack for a second time
immediately after a fast charging process has
been completed. This can give rise to the battery
pack becoming overcharged and to a reduced
service life of the battery and charging station.
Switch the charger off for at least 15 minutes
between two successive charging procedures.
Remove the power plug from the wall socket.
©
Insertion / removal of a battery
pack into the appliance
Ensure that the appliance is switched off before
inserting the battery. The insertion of a battery into
an electrical appliance that is switched on can lead
to accidents.
Inserting the battery pack:
Bring the rotation direction switch
middle position (Locked) and insert the battery
pack 7
Removing the rechargeable battery pack:
Press the release button
rechargeable battery pack
©

Checking battery status

To check the battery status, press the battery
LED button
sidual capacity will be indicated in the battery
LED
2
GREEN / RED / ORANGE = maximum charge /
capacity
RED / ORANGE = medium charge / capacity
RED = weak charge – recharge battery
Downloaded from www.Manualslib.com
12 extinguishes as soon
11
is ready for service.
7
into the handle until it engages.
and remove the
6
(see also Fig.). The status or re-
2
as follows:
manuals search engine
©

Changing tools

indicates
12
Your cordless electric drill / screwdriver has a fully
automatic spindle lock
enclosed keyless chuck incorporating the latest
signals to technology from
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch
©

Torque pre-selection

You can adjust the torque by using
selection. The torque levels regulate a range of up
to ca. 8 Nm.
Select a low setting for small screws, soft work
material.
Select a high setting for large screws, hard
work materials and for the extraction of screws.
into the For drilling, push the selector to the setting for
3
drilling, in that you adjust the torque pre-selector
to the position .
For drilling tasks, also push the gear selector
switch
©

2 Gear Drive

CAUTION! Move the gear selector switch
only after the device has come to a standstill.
Failure to observe this advice may result in damage
to the device.
In the first gear (Gear selector switch
in Position: 1)
A speed of up to approx. 400 rpm can be achieved
and a high torque. This setting is intended for use
with all screwing tasks and for accessories.
Before first use
and is fitted with an
"Made in Germany".
.
, you can immedi-
4
8
to the front (Position: 2).
1
can
9
).
torque pre-
1
1
GB/IE/CY 11