Changing Tools; Gear Drive; Torque Pre-Selection; Preparing The Tool For Use - Parkside X14,4-LI Bedienungs- Und Sicherheitshinweise

battery pack forward out of the charging
6
station.
7. Push the battery pack
device to insert the battery pack
device.

Changing tools

Q
Your cordless electric drill / screwdriver has a fully
automatic spindle lock
enclosed keyless chuck incorporating the latest
technology from
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch

2 Gear Drive

Q
note: Move the gear selector switch
after the device has come to a standstill.
Failure to observe this advice may result in damage
to the device.
In the first gear (Gear selector switch
in Position: 1)
A speed of up to approx. 400 rpm can be
achieved and a high torque. This setting is intended
for use with all screwing tasks and for accessories.
In the second gear (Gear selector switch
in Position: 2)
It achieves a speed of up to approx. 1200 rpm, for
the carrying out of drilling tasks.
from the front into the
6
into the
6
and is fitted with an
"Made in Germany".
can
9
.
, you can immedi-
).
4
only
1
1
Before first use / Preparing the tool for use

Torque pre-selection

Q
You can adjust the torque by using
selection.
When the value of the torque setting is reached, the
clutch disengages the drive connection to the chuck.
By doing this, screws can be driven to a predeter-
mined depth, which is ideal for repetitive work.
j
Select a low setting for small screws, soft work
material.
j
Select a high setting for large screws, hard
work materials and for the extraction of screws.
j
For drilling, push the selector to the setting for
drilling, in that you adjust the torque pre-selector
to the position .
j
For drilling tasks, also push the gear selector
switch to the front (Position: 2).
1

Preparing the tool for use

Q

Switching On /OFF

Q
m CAUTIOn! Make sure the device not operat-
ing when it contacts the screw. A rotating inserted
tool may slip. This could result in personal injury or
damage to the workpiece.
Switching on:
j
To start the appliance squeeze on the ON /
OFF switch
4
Switching off:
j
To stop the appliance, release the ON / OFF
switch .
4

Adjusting the speed

Q
1
The ON / OFF switch
regulator.
j
By increasing the pressure on the ON / OFF
switch you can increase the R.P.M.
4
torque pre-
8
and then keep it pressed down.
has a variable speed
4
GB/MT 31