Attention - Service Lines; Original Ancillaries / Accessories; Before First Use; Removing / Charging / Inserting Rechargeable Battery Pack - Parkside PABS 10.8 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

General safety advice for electrical power tools / Before first use
WARNING!
strike concealed electricity cables,
therefore when working you must
hold the electrical power tool by the
insulated handle areas only. Contact
with a live wire means that the metal parts of
the electrical power tools may become live and
this can result in an electric shock.
½
Before you carry out any tasks on the
device, transport or store it, make sure
that the direction of rotation switch is
in the middle position (lock). To prevent
the device from starting up unintentionally.
½
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.
©

Attention - Service lines!

WARNING!
you do not hit upon any service lines
(electricity, gas, water) when working
with electrical appliances. Check, if need be
with a service line detector, before you start to cut
or bore into a surface.
©
Original ancillaries /
accessories
½
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an in-
creased risk of personal injury for you.
10 GB/CY
Downloaded from www.Manualslib.com
The inserted tool may
Take steps to ensure that
manuals search engine
©
Before first use
©
Removing / charging / inserting
rechargeable battery pack
Note: The battery is supplied partially charged.
Charge the battery in the charging station for at
least three hours before first use. By doing this the
battery will operate at its highest capacity. You can
charge the Li-Ion battery at any time without risk of
shortening battery life. Interrupting the charging
process does not damage the battery.
1. In order to remove the rechargeable battery pack
, press the release buttons
8
rechargeable battery pack
2. Place the charging cap
battery pack .
8
3. Place the power supply unit
The status LED will shine red.
14
4. The green charge indicator LED
that the charging process is complete and the
battery pack is ready for use.
8
5. Insert the rechargeable battery pack
the device.
©

Checking the battery status

To check the battery status, press the button for
the rechargeable battery LED
diagram). The status or the remaining power
will be displayed in the rechargeable battery
LED as follows:
3
RED / ORANGE / GREEN = maximum charge /
performance
RED / ORANGE = medium charge / performance
RED = low charge – recharge battery
©

Changing tools

Your cordless drill / screwdriver has a fully automat-
ic spindle lock .
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
and take the
9
out of the device.
8
16 onto the rechargeable
into the socket.
13
15 shows you
8 into
2 (refer to main
can
12
.