Disposal And Recycling; Trouble Shooting - Scheppach 5903203901 Original Bedienungsanleitung

Disposal and recycling

12.
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.

13. Trouble shooting

Problem Possible cause
Engine, cable or connector
Engine does not run.
defective, fuses burnt.
The engine starts slowly
Voltage too low, coils damaged,
and does not reach the
capacitor burnt.
operating speed.
Engine producing
Coils damaged, motor defective.
excessive noise.
Circuits in the network are
Engine does not reach
overloaded (lamps, other engines,
full power.
etc.)
Overloading of the engine,
Motor overheats easily.
insufficient cooling of the engine.
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Have the machine checked by a specialist. Never repair
the engine yourself. Attention! Check the fuses and
replace them if necessary.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the same
circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum engine
cooling.