Residual Risks; Technical Specifications; Assembly - Scheppach 5903203901 Original Bedienungsanleitung

d) Keep unused electric tools out of the reach
of children. Do not let people use the electric
tool who are not familiar with it or who have
not read these instructions. Electric tools are
dangerous if they are used by inexperienced
people.
e) Maintain electric tools and accessories with
care. Check whether moving parts function
properly and do not get stuck and whether
parts are broken or are damaged and thus
adversely affect the electric tool function.
Have damaged parts repaired before using
the electric tool. Many accidents are caused by
poorly maintained electric tools.
f) Always keep cutting tools sharp and clean.
Carefully maintained cutting tools with sharp
cutting edges seize up less often and are easier
to guide.
g) Use electric tools, accessories and tool
attachment, etc. according
instructions. Take the working conditions and
the activity to be carried out into consideration.
Using electric tools for applications other than the
intended uses can lead to dangerous situations.
h) Keep the handles and gripping surfaces dry,
clean and free of oil and grease. Slippery
handles and gripping surfaces prevent safe
operation and control of the electrical tool in
unforeseen situations.
5 Service
a. Only have your electric tool repaired by
qualified specialists and only with original
spare parts. This ensures that safety of the
electric tool is maintained.
m ATTENTION! This electric tool generates an
electromagnetic field during operation. This field
can impair active or passive medical implants
under certain conditions. In order to prevent the
risk of serious or deadly injuries, we recommend
that persons with medical implants consult with
their physician and the manufacturer of the medical
implant prior to operating the machine.
Safety instructions for grinding machines
• Do not use damaged accessories. Check
the accessories, e.g. the grinding disc for
cracks before each use. After inspection and
installation of an accessory, remove yourself
and bystanders from the machine and allow
the electric tool to run at maximum idle speed
for one minute. Damaged accessories normally
break during this test period.
• The nominal speed of the accessories must be
at least equal to the maximum speed indicated
on the electric tool. Accessories that run faster
than the nominal speed may break.
• Never grind on the sides of a grinding disc.
Lateral grinding can cause the grindstone to break.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

5. Residual risks

The machine has been constructed according to the
state of the art and the recognized safety rules. Nev-
ertheless, single residual risks may occur during the
operation.
• The rotating grinding wheel may cause injuries of
fingers and hands.
• Danger caused by electric current if inappropriate
electrical connecting lines are used.
• Furthermore, non obvious residual risks may exist
in spite of all measures taken.
• Residual risks can be minimized by carefully ob-
serving the safety instructions and the intended
use as well as the entire operating instructions.

6. Technical specifications

Dimensions LxWxH mm
to these
Tool rest ø mm
Grinding stone ø mm
Idle-running speed - grinding
stone
1/min.
Cutting speed m/sec.m/sec.
Weight kg
Drive
Motor V
Input P1 W
Output P2 W
Motor speed 1/min.
Operating mode
Current rating A
Subject to technical modifications!

7. Assembly

Assemble the stone and the tool table and hang the
water tank as in Figure 1 on the machine.
Installation and Adjustment
Please make sure that your grinding machine is in-
stalled in an upright and stable manner on a firm
ground with sufficient illumination.
The machine has no front or rear side. You can alter-
natively grind with or against the direction of rotation.
380x290x390
12
250
90-150
1,2-2
13
230 – 240
180
80
1950-3250
S1
0,95
GB | 19