Electrical Connection; Cleaning And Maintenance; Storage And Transport - Scheppach 5903203901 Original Bedienungsanleitung

Expert tip: You can work in the free-handed mode
for the trimming itself. You achieve a more precise
result if you keep the tool in the device in the position
in which you ground the tool.
With the star grip screw on the rear side of the ma-
chine housing (see Figure 2), you can set the contact
pressure on the friction wheel. This is necessary if
when trying the honing wheel stops.

9. Electrical connection

The installed electric motor is connected and is ready
to work.
The connection complies with the relevant VDE and
DIN regulations.
The connection to the mains supply on the customer
side and the used extension line must meet these
regulations or the provisions of the local power sup-
ply company.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insula-
tion damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the marking „H05VV-F".
The printing of the type designation on the connec-
tion cable is mandatory.
A.C. Motor
• The supply voltage must be 220­240 V/50 Hz.
• Extension lines up to a length of 25 m must have
a minimum cross section of 1.5 mm², lines with a
length exceeding 25 m must have a minimum cross
section of 2.5 mm².
• The mains connection is protected with a maximum
of 16 A.
Connections and repairs of the electrical equipment
may only be performed by an electrician.
If you have further questions, please specify the fol-
lowing:
• Motor manufacturer and type
• Kind of current of the motor
• Data from the machine type plate
• Data of the electric control
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
If you return the motor, always return the complete
drive unit with the electric control.

10. Cleaning and maintenance

m Warning! Switch off the machine and pull out the
mains plug before performing setting, maintenance
or service work!
Cleaning
Keep all safety devices, ventilation slots and the
engine housing free from dirt and dust insofar as
possible. Wipe the device clean with a clean cloth or
blow it off with compressed air at low pressure.
We recommend cleaning the device immediately
after each use.
Maintenance
The device has no further internal parts that require
maintenance.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: grinding medium, carbon brushes,
sharpening wheel, angle gauge, v-belt
* Not necessarily included in the scope of delivery!

11. Storage and transport

Store devices and accessories out of the reach of
children in a dark and dry place above freezing point.
The ideal storage temperature lies between 5 and 30
°C. Store the electric tool in its original packaging.
Store the grindstone in a cool, dry and dark place.
m Attention! It is essential that the device is secured
against falling or tipping over during transport.
The machine may only be lifted and transported by
its frame.
GB | 21