Troubleshooting - JUNO JB084C1 Benutzerinformation

The screen-printing zone must face the in‐
ner side of the door. Make sure that after
the installation the surface of the glass pan‐
el frame on the screen-printing zones is not
rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal glass
panel in the seats correctly.
How to replace: Lamp
WARNING! Risk of electric
shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until
the oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
In any cases not included in this table
please contact with an Authorised Service
Centre.
Problem
The oven does not
heat up.
Before you replace the lamp:
Step 2
Disconnect the oven from
the mains.
Check if...
The fuse is blown.
Always hold the halogen lamp with a cloth
to prevent grease residue from burning on
the lamp.
Put a cloth on the bottom of
Problem
The door gasket is
damaged.
The display shows
"12.00".
29
A
Step 3
the cavity.
Check if...
Do not use the
oven. Contact an
Authorised Service
Centre.
There was a power
cut. Set the time of
day.