Operation; Transport - Kärcher NT 40/1 Ap L Originalbetriebsanleitung

 Dispose of the dust bag (special acces-
sory) in accordance with statutory provi-
sions.
 Insert and lock the suction head.
– To vacuum wet dirt, always remove the
disposal bag (option).
General
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if mostly wa-
ter is suctioned from a container it is
recommended not to activate the "man-
ual filter dedusting" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All accessories with a nominal
width of 35 mm can be connected.

Operation

Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the rotating
knob.
Installing the tool adapter
Illustration
 Remove the elbow from the suction
hose.
 Attach the tool adapter to the suction
hose.
Semi-automatic filter dedusting
Note: A filter dedusting every 5 to 10 min-
utes will increase the life of the flat folded
filter.
Note: The semi-automatic filter dedusting
function can only be switched on when the
appliance is switched on.
 Press the semi-automatic filter dedust-
ing key five times. The flat folded filter is
automatically cleaned through an air jet
(pulsating sound).
Illustration
 Power dedusting (especially with se-
vere soiling of the flat pleated filter):
Cover the suction tube or the bender
with your hand and press the semi-au-
tomatic filter dedusting key five times
with the appliance switched on.
Turn off the appliance
 Press the semi-automatic filter dedust-
ing key five times.
 Switch off the appliance at the rotating
knob.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
Illustration
 Store the suction hose and the mains
cable as shown in the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance by the handle and at the suction
pipe to transport it, not by the push han-
dle.
– 4
EN

Transport

17