Operation; Initial Startup; Switching On The Unit - Kärcher IVM 100/36-3 Oss Bedienungsanleitung

Lever for the filter cleaning
15
Illuminated pressure switch
16
Suction turbine power switch
17
Cable hooks
18
Mains cable
19
Suction head lock
20
Spacer lock
21
Suction hose port
22
Bow handle of the dirt receptacle
23
Fill level sensor plug
24
Fill level sensor
25
Chassis
26

Initial startup

ATTENTION
Exceeding the grid impedance
Electrical shock in the event of a short-cir-
cuit
The maximum permissible mains grid im-
pedance at the electrical connection point
(see Technical data) must not be exceed-
ed.
Contact your electricity supplier in the case
of any uncertainties regarding the mains
grid impedance at your electrical connec-
tion point.
1. Bring the device into the working posi-
tion.
2. Secure the device with the parking
brakes.
3. Insert the suction hose into the suction
connection.
4. Plug the desired accessory onto the suc-
tion hose.
5. If necessary, fit a dust collection bag in
the dirt receptacle (see chapter Fitting
the dust collection bag).
6. Ensure that the dirt receptacle is correct-
ly fitted.
Fitting the dust collection bag
A dust collection bag can be inserted into
the dirt receptacle to allow dust-free empty-
ing of the device.
Note
The dust collection bag must not be used
for wet vacuum cleaning.
1. Fit the dust collection bag in the dirt re-
ceptacle and carefully press it against
the wall of the container.
2. Fold the edge of the bag over the edge
of the dirt receptacle.
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
3. Fit the dirt receptacle in the device.
After vacuuming moist or liquid substances,
see chapter Switching from wet to dry vac-
uuming.

Switching on the unit

1. Plug the mains plug into the socket.
The illuminated pressure switch lights
up.
Illustration B
2. Press the illuminated pressure switch.
The light goes out.
3. Switch on the device via the suction tur-
bine power switches.
Note
Select the required suction power via the
suction turbine power switch, starting with
suction turbine 1. Always switch the suction
turbines on and off one after the other.
4. Start the vacuuming process.
Performing the vacuuming process
Note
The unit has a fill level sensor that automat-
ically switches the unit off when the dirt re-
ceptacle is full.
1. If necessary, but at the latest when the
fill level sensor switches off the unit,
empty the dirt receptacle (see chapter
Emptying the dirt receptacle).
English

Operation

13