Short Instruction; Full Auto Teaching (With An Object Moving) - Balluff BOS 73K-Serie Bedienungsanleitung

Short instruction

2.2

Full auto teaching (with an object moving)

„T" or „T " must be visible in the display (set by placing slide switch to SELECT and
V
pressing button 1 repeatedly) and the slide switch must be in the „RUN" position.
Push button 1 and hold it down for at least 3 seconds.
Allow object to pass by.
Release button 1.
Setting done
2.3 External Teach in
The same procedure like in 2.1 and 2.2. The external Teach (Remote ) replaces button 1.
(External Teach must be connected to + U
3 Manual setting
3.1 Manually setting the switching threshold
„S" must be visible in the display (set by placing slide switch to SELECT and pressing
button 1 repeatedly) and the slide switch must be in the „MODE" position.
If an object is placed in front of the fibre the light amount is displayed in 3 digits.
The flushing digit can be increased with button 1.
Push button 2 to skip to the next digit.
After setting the slide switch to „RUN" the device is ready.
3.2 Hysteresis selection
„H" must be visible in the display (set by placing slide switch to SELECT and pressing
button 1 repeatedly) and the slide switch must be in the „MODE" position.
The flushing digit can be increased with button 1.
Push button 2 to shift digit.
After setting the slide switch to „RUN" the device is ready.
3.3 Timer changeover
Push button 2, hold it down and turn the switch from „RUN" to „SELECT".
The timer can be selected by pushing button 1.
After selection is completed, replace the switch to „RUN".
at least 50 ms)
B
31