Balluff BOS 73K-Serie Bedienungsanleitung Seite 54

"S" Manual setting for operation level/sensitivity
(Function)
In + / - indication
( Light variation indication )
1) Turn the switch to SELECT to show SELE.
2) Push button 1 and select "S". Turn the switch to MODE.
SELECT
RUN
The present operation level is shown.
Shows that exceeding the value 288 results in an output.
3) Push button 1 to count up the
flashing figure.
Push button 2 to shift digit.
Set proper value by repeating procedure.
4) After completed, replace the switch to RUN. The changover is completed
Addition
- + / - changeover is impossible.
- It is output trigger value ( On - operation level ) that can be changed.
Light-On: On value when light enters.
Dark-On: On value when light is interrupted.
- Hysteresis is automatically set at 4.
- Changeover renge: Differs depending on the base value regarded
as the standard (± 0 ).
On level changover range is 9 to 999 in light level indication mode.
It is impossible to exceed this range.
( Ex. ) Providing incoming light level = 600 as a standard
value, changeover range is 999 - 600 = 399.
- Out of range: OUT is shown for out changeover range.
SELECT
RUN MODE
MODE
S
BOS 73
Oparation level is shown as
"+288" in the illustration.
BOS 73
SELECT
RUN MODE
SELECT
RUN
MODE
SELECT
RUN MODE
23