Amplifier - Balluff BOS 73K-Serie Bedienungsanleitung

Amplifier unit
1) How to install the case cover
How to open the case cover
Pull up the tab of the case cover holding
the front part of the case cover.
Pulling up only the tab of the case cover forcefully may damage the case
cover. Do not fail to hold the front part of the cover when pulling up the tab.
Half opened condition
When opening the cover, you
will feel a click as it opens,
and you can stop in the half
opened condition.
2) How to attach the case cover
Put the cover on the amplifier
unit shown in the figure and push
the hinge.
How to install the amplifier unit onto the DIN rail / the mounting bracket
1) How to attach
Hook the front hook of the
amplifier unit onto the rail (or the
mounting bracket) and press the
rear part of the
amplifier unit.
3) Side mounting of amplifier unit
Fasten with screws by using the attached mounting
bracket. Tightening torque should be 0.8Nm or less.
6
Press the front part of the cover after
pushing the hinge. Confirm fixing of
the cover with a click.
Push Push
2) How to detach
Pushing the amplifier unit towards
the front, pull the front up and the
front hook comes off.
Push Push
Full opened condition
Push the edge of the cover when the
cover is fully opened, and the cover
will be detached.
Push Push
Push Push
M3 M3