Back Panel - Dell Emc Poweredge R830 Bedienungsanleitung

Identifier
Version
Status

Back panel

Figure 5. Back panel features
1. Full-height PCIe expansion card slot on Riser 1 (2)
3. Full-height PCIe expansion card slot on Riser 3(2)
5. Power supply unit 1
7. System identification port
9. Video port
11. Ethernet port
13. USB 2.0 port
Table 3. Back panel features
Item Indicator, button, or
connector
1 Full-height PCIe expansion
card slot on Riser 1 (2)
2 Half-height PCIe expansion
card slot on Riser 2 (3)
3 Full-height PCIe expansion
card slot on Riser 3 (2)
4 Power supply unit (PSU2)
5 Power supply unit (PSU1)
6 System identification button
GUID-C7B4F84A-2D44-43E6-883F-B69FFDAE1DDF
3
Released
Icon
2. Half-height PCIe expansion card slot on Riser 2 (3)
4. Power supply unit 2
6. System identification button
8. iDRAC8 Enterprise port
10. Serial port
12. USB 3.0 port
Description
Use the card slots to connect up to two full-height PCIe
expansion cards on Riser 1.
Use the card slots to connect up to three half-height PCIe
expansion cards on Riser 2.
Use the card slots to connect up to two full-height PCIe
expansion cards on Riser 3.
For information about supported PSUs, see the Technical
specifications section.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
● If the system stops responding during POST, press and
hold the system ID button (for more than five seconds)
to enter the BIOS progress mode.
Dell PowerEdge R830 – Übersicht 15