Dell EMC PowerEdge R830 Bedienungsanleitung Seite 11

Figure 3. Front panel features (2.5-inch hard drive chassis)
1. Power button
3. System identification button
5. LCD menu buttons
7. LCD panel
9. vFlash media card slot
11. USB management port/iDRAC Direct
Table 1. Front panel features (2.5-inch hard drive chassis)
Item Indicator, button, or
connector
1 Power button
2 NMI button
3 System identification button
4 Video connector
5 LCD menu buttons
2. NMI button
4. Video connector
6. Information tag
8. Hard drives
10. USB port
12. Optical drive
Icon Description
Press the power button to turn the system on or off. The
indicator on the button indicates if the system is on or off.
NOTE:
operating system, press the power button.
Press the NMI button to troubleshoot software and device
driver errors when running certain operating systems. Use the
end of a paper clip to press the NMI button.
NOTE:
qualified support personnel or by the operating system
documentation.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
● If the system stops responding during POST, press and
hold the system ID button (for more than five
seconds) to enter the BIOS progress mode.
Use the video/VGA port to connect a display to the system.
For more information about the supported video/VGA port,
see the Technical specifications section.
Press the LCD menu buttons to navigate the control panel
LCD menu.
To gracefully shut down an ACPI-compliant
Use the NMI button only if directed to do so by
Dell PowerEdge R830 – Übersicht 11