Dell EMC PowerEdge R830 Bedienungsanleitung Seite 177

CAUTION: To prevent damage to the processor pins when replacing a faulty system board, ensure that
you cover the processor socket with the processor protective cap.
l. Memory modules and memory module blanks
m. Network daughter card
Steps
1. Disconnect all cables from the system board.
CAUTION: Take care not to damage the system identification button while removing the system board from
the chassis.
CAUTION: Heben Sie die Systemplatinenbaugruppe nicht an einem Speichermodul, einem Prozessor oder
anderen Komponenten an.
2. Hold the system board holder, lift the blue release pin, lift the system board, and then slide it toward the front of the chassis.
Sliding the system board toward the front of the chassis disengages the connectors from the back of the chassis slots.
3. Lift the system board out of the chassis.
Figure 93. Removing the system board
a. thumb screw
b. system board holder
c. system board
Next steps
1. Install the system board.
Installieren und Entfernen von System-Komponenten 177