Herunterladen Inhalt Inhalt Diese Seite drucken

Fehlerbehebung Bei Einem Seriellen Eingabe-Ausgabe-Gerät - Dell Emc Poweredge R830 Bedienungsanleitung

Inhaltsverzeichnis
Verwandte Verweise
Wie Sie Hilfe bekommen
on page 209
Identifier
Version
Status
Fehlerbehebung bei einem seriellen Eingabe-Ausgabe-
Gerät
Voraussetzungen
Schritte
1. Schalten Sie das System und die an die serielle Schnittstelle angeschlossenen Peripheriegeräte aus.
2. Ersetzen Sie das serielle Schnittstellenkabel durch ein anderes, funktionierendes Kabel und schalten Sie das System und das
serielle E/A-Gerät ein.
Wenn sich das Problem auf diese Weise lösen lässt, muss das Schnittstellenkabel gegen ein funktionsfähiges Kabel
ausgetauscht werden.
3. Schalten Sie das System und das serielle E/A-Gerät aus und tauschen Sie das serielle Gerät gegen ein kompatibles Gerät
aus.
4. Schalten Sie das System und das serielle E/A-Gerät wieder ein.
Nächste Schritte
Wenn das Problem weiterhin besteht, lesen Sie den Abschnitt „Wie Sie Hilfe bekommen".
Verwandte Verweise
Wie Sie Hilfe bekommen
on page 209
Identifier
Version
Status
Troubleshooting a NIC
Voraussetzungen
ANMERKUNG:
Network Daughter Card (NDC) slot is not hot-pluggable.
Schritte
1. Run the appropriate diagnostic test. For more information, see the Using system diagnostics section for the available
diagnostic tests.
2. Restart the System and check for any system messages pertaining to the NIC controller.
3. Check the appropriate indicator on the NIC connector:
● If the link indicator does not glow, the cable connected might be disengaged.
● If the activity indicator does not glow, the network driver files might be damaged or missing. Install or replace the drivers
as necessary. For more information, see the NIC documentation.
● Try another known good network cable.
● If the problem persists, use another connector on the switch or hub.
4. Ensure that the appropriate drivers are installed and the protocols are bound. For more information, see the NIC
documentation.
5. Enter System Setup and confirm that the NIC ports are enabled on the Integrated Devices screen.
GUID-659F00AB-451A-4F65-A1B5-F81CBC725D7F
10
Translation Validated
GUID-7773C999-4E5B-4E57-AA5F-C61B5E28EE3A
17
To be translated
Fehlerbehebung beim System
195
Inhaltsverzeichnis
loading

Diese Anleitung auch für:

E21s serieE21s002

Inhaltsverzeichnis