Dell EMC PowerEdge R830 Bedienungsanleitung Seite 179

Figure 94. Removing the system board
a. thumb screw
b. system board holder
c. system board
Next steps
1. Install the Trusted Platform Module (TPM). For information about how to install the TPM, see the Installing the Trusted
Platform Module section.
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module will be provided for all system board replacements where a TPM plug-in module was installed.
2. Replace the following components:
a. Cable retention bracket
b. PCIe card holder
c. Integrated storage controller card
d. Internal USB key, if applicable
e. Internal dual SD module
f. All expansion card risers
g. Heat sinks or heat sink blanks
h. Processors or processor blank
i. Memory modules and memory module blanks
j. Network daughter card
k. Cooling fan assembly
l. Cooling shroud, if installed.
m. Power supply unit
Installieren und Entfernen von System-Komponenten 179