Safety Requirements; General Informations; Personal Protection - Jackle ProTIG 350 DC Betriebsanleitung

18. Safety requirements

11.1 General Information's
This welding unit has been manufactured in accordance with the relevant international standards.
However, improper use or manipulation of the machine may cause hazards.
The following safety instructions must be strictly observed:
a) This unit is exclusively intended for the TIG and electrode welding process.
Welding operations with the TIG welding unit should be carried out be qualified
persons. Service personnel must be duly informed of all safety rules.
b) Electrical repair work must be carried out by qualified electricians
c) Always disconnect mains prior to servicing, maintenance, and repair work and before
opening the casing.
11.2 Electrical Information's, Fire

11.3 Personal Protection

11.4 Welding fumes and gases
The air inhaled by the welder must be kept free from harmful substances caused
during welding process. The ventilation required depends on the size of the en-
closed working area, the type of material used and the duration of the welding
process. In some cases, ventilation (e.g. fan) may be sufficient, but usually an
extraction system is necessary where harmful substances are produced.
Operating manual
The welder must be protected against arc radiation and burn-
ing by wearing adequate protective clothing such as a leather
apron, leather jacket, leather gloves etc.
Inflammable substances must be kept away from the welding
area. They might catch fire from sparks or hot slag.
Mains cable, hose pack, and workpiece cable must be perfect-
ly insulated. Any defective insulation must be repaired immedi-
ately.
The face and the eyes must be protected by a welder´s shield
with lenses - protection category corresponding to the intensity
of current.
Persons working close by must also be adequately protected
from arc radiation.
To protect your hearing against noise,
wear ear-protectors!
Protect your hands and feet by wearing stout footwear and
appropriate gloves.
ProTIG 350 AC/DC
Page 24