Electric Connection - OEM DOME Bedienungsanleitung

3.3 - ELECTRIC CONNECTION

DANGER
• The power feed line should be provided
with a suitable omni-polar DISCONNECT-
ING SWITCH (automatic thermo-magnetic
switch or differential) placed before the
control unit main switch, with a minimum
contact opening of 3 mm.
• The earthing system should comply with
the local electric regulations in force.
• The electric power cables are charged to
the customer and must be sized accord-
ing to the maximum current consumption.
The cable shall be a flexible, oil-resistant
sheathed cable and shall not be lighter than
polycropylene or synthetic elastomer ca-
bles under equivalent sheath (designation
60245 IEC 57) and in any case must comply
with the rules in force in the country of use.
• The specifications of the electric power
line should correspond to the specifica-
tions of the identification plate and to
those mentioned in the technical speci-
fications table that can be consulted in
the first part of this booklet.
DANGER
Before connecting the machine to the
electric line, make sure that the DISCON-
NECTING SWITCH is disconnected (line
not energized).
IMPORTANT
The line disconnector located upstream of the
oven must be in an area easily accessible by
the operator during all operating and mainte-
nance activities of the oven.
EN - 16
FIG. 11
2
1
L1
L2 L3
DOME
Installation and connections
4
3
4
T
N