Function Test; Power Connection - Scheppach OX 1 Serie Originalanleitung

Function Test

Action: Result:
Pressing both handles down.
Operating Instructions
Travel limit for short logs, fig. 4
height and refasten the tommy screw.
Splitting
Never in horizontal position or across.
Efficient working
NB! Using the splitting cross reduces the distance by 4 cm.
Adjusting the table height (Ox 1-600 and -700), fig. 5
Pivoting table for short logs (Ox 1-1000), fig. 6
If you want to transport the machine, do not lift at the table!
Start-Up
moves down - as
above the table.
-
-
-
Power on/off
Note:
use by switching it on and off once.
Restart cut-out in case of power failures (zero voltage
switch)
on the switchbox again.

Power Connection

(German Association for Electrical, Electronic, and Infor-
designation.
Faulty power cords
Power cords often suffer insulation damage.
The causes of this are:
or door cracks.
er outlet.
the damaged insulation, a danger to life!
AC motor 230 V/ 50 Hz
Power supply 230 volts / 50 Hz.
Power cord and extension cord must have 3 conductors =
The extension wires must have a cross-section of at least
1.5 mm².
circuit breaker.
Three-phase motor 400 V/ 50 Hz
Power supply 400 volts / 50 Hz.
Power cord and extension cord must have 5 conductors
The extension wires must have a cross-section of at least
1.5 mm².
circuit breaker.
-
-
english 13