Troubleshooting - Dometic CF-Serie Bedienungsanleitung

Troubleshooting

8 Troubleshooting
Problem
Device does not function,
"POWER" LED does not light
up.
CF11, CF26: The device
does not cool (plug is
inserted, "POWER" LED is
lit).
CF11, CF16: The device
does not cool (plug is
inserted, "POWER" LED
flashes, display is empty).
When operating from the
DC outlet:
The ignition is on and the
device is not working and
the "POWER" LED is not lit.
18
Possible cause
No voltage is flowing
from the DC power
socket in your
vehicle.
No voltage present in
the AC voltage
socket.
The device fuse is
defective.
The integrated mains
adapter is defective.
Defective
compressor.
The voltage is too low
at the 12/24 V
socket.
The DC outlet is dirty.
This results in a poor
electrical contact.
The fuse of the DC
plug has blown.
The DC fuse inside
the device has blown.
The vehicle fuse has
blown.
Suggested remedy
The ignition must be switched on in
most vehicles to supply current to
the on-board power socket.
Try using another plug socket.
Replace the device fuse, see chapter
"Replacing the AC fuse" on page 16.
This can only be repaired by an
authorised repair centre.
This can only be repaired by an
authorised repair centre.
Check the battery and charge if
necessary.
Check the cables and connections.
If the plug of your cooler becomes
very warm in the DC outlet, either
the DC outlet must be cleaned or the
plug has not been assembled
correctly.
Replace the fuse in the DC plug, see
chapter "Replacing the plug fuse
(12/24 V)" on page 16.
This can only be repaired by an
authorised repair centre.
Replace the vehicle's DC outlet fuse.
Please refer to your vehicle's operat-
ing manual.
CoolFreeze
EN