CoolFreeze
➤ Replace the defective fuse (2) with a new one that has the same rating
(T8 A 32 V).
➤ Re-assemble the plug in the reverse order.
I
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorised repair
centre.
6.14
Replacing the bulb (CF16, CF26)
➤ Press the switch pin (fig. 8 2, page 4) downwards so that the transparent part
(fig. 8 1, page 4) of the lamp can be removed at the front.
➤ Replace the light bulb.
➤ Press the transparent part of the lamp back into the housing.
7
Cleaning and maintenance
A
NOTICE! Damage hazard
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
EN
Cleaning and maintenance
17