Maintenance And Cleaning; Maintenance Intervals; Changing The Cutter - Abicor Binzel BRS-CC Einbauanleitung

9 Maintenance and cleaning

9 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
During such activities, observe the following:
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Disconnect the power supply.
• Interrupt the compressed-air supply.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel
• Always wear your personal protective equipment when performing maintenance and cleaning work.

9.1 Maintenance intervals

NOTICE
• The specified maintenance intervals are guidance values and refer to single-shift operation.
When using arc welding equipment, always observe the provisions of EN 60974-4 Inspection and testing
plus any national laws and regulations.
Check the following:
Weekly
1 Check the condition of the reamer.
2 Clean the clamping unit and the reamer.
3 Grease the cutter guide after approx. 10,000 cuts.
Tab. 16 Maintenance intervals

9.2 Changing the cutter

The service life of the cutter depends on the filler materials used.
1 Unscrew the retaining plate with a lubricating nipple.
2 Unscrew and replace the cutters.
3 Screw on the retaining plate again.
4 Check the fixed jaws for wear; reverse or replace if necessary.
EN - 20
DANGER
DANGER
(in Germany see TRBS 1203).
Monthly
Monthly basic cleaning is recommended, and necessary in the
case of extreme working conditions.
BRS-CC