Maintenance And Cleaning - Abicor Binzel BRS-LC Betriebsanleitung

8 Operation
8 Operation
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Consult the documentation for the welding components.
• Make sure that the BRS-LC is operated with the delivered protective device only.
1 Switch on the robot control.
2 Start the welding process.
3 Stop the welding process.
9 Putting out of operation
NOTICE
• When decommissioning the system, ensure that the procedures for switching off the welding components are
observed.
1 Switch off the robot control.

10 Maintenance and cleaning

Regular maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting, dismounting and
repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Always wear your personal protective clothing when performing maintenance and cleaning work.
EN - 18
BRS-LC
BAL.0030 • 2019-01-18