Change The Pump Oil; 10.2.1 For Countertop Models - Nordcap mychef iSensor S Bedienungsanweisung

10.2 Change the pump oil
Material needed for the oil change:
Material: Synthetic oil SAE 10 VSL32 (countertop models)
•
Tools:
•
Warning: Before removing any components, verify that the appliance is disconnected
from the electricity grid and the water supply.
10.2.1 For countertop models
Step 1à Remove the two rear screws
Using the number 3 Allen wrench, remove the two rear screws on the sides (do not remove the front
screws because the well pivots on them). After removing these two screws, use the same Allen wrench
to loosen the centre screw on the rear (it is not necessary to remove it completely).
Figure 2. Oil replacement kit
Number 3 Allen wrench.
o
Adjustable wrench
o
20