Errors - Nordcap mychef iSensor S Bedienungsanweisung

8.

ERRORS

The device uses algorithms that detect abnormal situations which could lead to
malfunctioning. The user is notified of these situations with an error screen such as the one
shown below:
The table below shows the errors and possible solutions:
Error Description
E01 Lowered lid
E02 Error in the vacuum system
E03 Error in the vacuum sensor
(minimum)
E04 Error in the vacuum sensor
(maximum)
E05 Internal error
The appliance runs automatic checks and, as a result, it may turn itself off to prevent a serious
error. Turn it on as usual.
In the event of an error with the vacuum packer, please contact the technical
service.
Figure 8. Error screen
Solution
Open the lid. If the error persists, call the technical service, indicating the error
code.
The system has detected that the vacuum pump has operated too long to reach
a certain vacuum level. Calibrate the system. If the calibration is carried out
successfully, conduct the test again. Otherwise, call the technical service. The
maximum operating time is 2 minutes.
Check the vacuum sensor connection tube for leaks or a poor connection. If
everything seems correct, call the technical service indicating the error code
and the central display value right before the error.
Check the vacuum sensor connection tube for leaks or a poor connection. If
everything seems correct, call the technical service indicating the error code
and the central display indicator value right before the error.
The control board has detected an internal error. Call the technical service,
stating the error code.
Table 2. Errors and possible solutions
17