Autoclean - Nordcap mychef iSensor S Bedienungsanweisung

iSeal algorithm, which regulates the time automatically. This parameter is represented by
the "SEALING" icon.
Atmospheric pressure restoration mode:
-
This parameter allows for the selection of 3 types of air entry:
1. FAST: The restoration of atmospheric pressure in FAST mode allows air to enter
suddenly through the opening of an entry valve until atmospheric pressure is restored
inside the chamber. It is the fastest and most appropriate mode in most cases.
2. SOFT: Pressure restoration in SOFT mode allows for the entry of air in an intermittent
manner, thus controlling any deformations that may occur to the bag. This mode is
useful for the slow restoration of atmospheric pressure, so that the packed food
moulds correctly to the bag and prevents sharp or pointy elements from breaking it.
3. STOP: This mode makes it possible to stop the pump at a certain vacuum value by
pressing the centre button or until the value determined by the vacuum percentage is
reached. The vacuum packer will maintain this vacuum until the button is pressed
again. This process may be useful for marinating meats or fish or to extract air from
sauces.
This parameter is identified by the "AIR" icon and each type of restoration is selected using
the icons located below: "FAST", "SOFT" and "STOP".
Multiple vacuum cycle repetitions:
-
It is possible to program a series of repetitions of the same vacuum cycle. This makes it
possible to perform the vacuum process and restore the atmospheric pressure in the
vacuum packer in a cyclical manner. On each repetition, the vacuum packer reaches the
value configured in the "vacuum percentage" parameter. If this value is 100% and extra
vacuum time is programmed, this time will also be completed on each repetition.
Atmospheric pressure is then restored in the chamber. The pressure is not fully restored as
a small vacuum percentage is maintained in the chamber, preventing the lid from opening
and allowing another repetition to begin automatically.
This process will be carried out as many times as programmed, up to a maximum of 9
times. This process is represented by the "REPEAT" icon and the digit below it shows the
number of repetitions remaining.
Gas injection is compatible with the multi-cycle mode, although keep in mind that the gas
will only be injected in the last repetition, as with sealing.
7.3.3

Autoclean:

When the vacuum pump's oil has taken on a whitish shade, due to water condensation, it can
be removed using this mode. Due to the temperature, this process means any water that may
be in the oil will end up evaporating and exiting the pump.
These water particles may cause rust particles to develop on internal components of the
pump.
14