Description Of Appliance; Technical Specifications; Recommended Open-Outlet Taps; Optional Swivel Outlets - clage M3-O Gebrauchs- Und Montageanleitung

Description of appliance

2. Description of appliance
This instantaneous water heater is intended to provide the economical heating of water suffi-
cient for a single outlet, i.e. handwash basin, and must be connected to a special open-outlet
tap to avoid any overpressure. Appliances with a higher power rating can also be used to
supply a kitchen sink. They will also provide a basic shower when used with a special shower
fitting.
When the hot water tap is opened, the instantaneous water heater switches itself on auto-
matically and heats the water as it passes through the appliance. It is only then that the appli-
ance uses electricity. The temperature increase depends on the flow rate.

2.1 Technical specifications

Type
Energy efficiency class
Capacity
Max. operating pressure
Heating system
Min. water resistance at 15 °C
Max. water inlet temperature
Rated voltage
Rated power
Rated current
Required min. cable cross-section
Hot water output at ∆t = 25 K
Switching on at
Switching off at
Approx. weight when filled with water
Protection class
Marking / Approvals
*) The declaration complies with the requirements of the EU regulation No 812/2013 being binding as of September 2015.
1) The specific resistance can be asked for at your water distribution company. 2) Temperature increase from e. g. 15 °C to 40 °C.

2.2 Recommended open-outlet taps

SMB/ LS
Art.-No. 1100-04100

2.2.1 Optional swivel outlets

LS 12
Art.-No. 0010-0052
Litre
MPa (bar)
1) Ωcm
°C
kW
A
mm 2
l/min
2)
l/min
l/min
kg
SME
Art.-No. 1100-04150
LS 20
Art.-No. 0010-0054
M 3-O M 4-O
0 (0); Open outlet only!
IES® bare wire heating system
1~ / N / PE 230 V AC
3.5 4.4
15.2 19.1
1.5 2.5
2.0 2.5
1.3 1.8
1.0 1.4
LS 30
Art.-No. 0010-0055
23
M 6-O
A *)
0.2
1100
20
2~ / PE 400 V AC
5.7
24.8
4.0
3.3
2.2
1.7
1.5
IP 25
see rating plate
EN
M 7-O
6.5
16.3
1.5
3.7
2.4
2.0
BGS
Art.-No.
1100-04300