Copying Illumination Scenes; Copying A Complete Memory Bank; Deleting Individual Illumination Scenes; Deleting All Illumination Scenes - EuroLite DMX OPERATOR 240 Bedienungsanleitung

7
Store the scene on its original memory
location with the buttons SCENE 1-8. To
confirm the memory procedure, all LEDs of
the controller flash three times.
8
After the revised scene has been
memorized, switch off the programming
mode. For this, keep the button PROGRAM
pressed until the LED next to the button
extinguishes.

Copying Illumination Scenes

1
Call the programming mode. For this, keep
the PROGRAM pressed until the LED next to
the button flashes.
2
Use the buttons BANK UP and BANK
DOWN to select the memory bank (1-30)
where the desired scene is stored.
3
Load the scene to be copied (source) with
the corresponding button SCENE 1-8.
4
Use the buttons BANK UP and BANK
DOWN to select the memory bank you would
like to copy the scene to (target).
5
Press the button MIDI/REC.
6
Use one of the buttons SCENE 1-8 to select
the desired memory location. The scene is
memorized. To confirm the memory
procedure, all LEDs of the controller flash
three times.
7
After the scene has been copied, switch off
the programming mode. For this, keep the
button PROGRAM pressed until the LED
next to the button extinguishes.

Copying a Complete Memory Bank

1
Call the programming mode. For this, keep
the PROGRAM pressed until the LED next to
the button flashes.
2
Use the buttons BANK UP and BANK
DOWN to select the memory bank (1-30) to
be copied (source).
3
Press the button MIDI/REC.
4
Use the buttons BANK UP and BANK
DOWN to select the memory bank to copy
into (target).
5
Press the button MIDI/REC to memorize. To
confirm the memory procedure, all LEDs of
the controller flash three times.
6
After the bank has been copied, switch off
the programming mode. For this, keep the
button PROGRAM pressed until the LED
next to the button extinguishes.

Deleting Individual Illumination Scenes

1
Call the programming mode. For this, keep
the PROGRAM pressed until the LED next to
the button flashes.
2
Use the buttons BANK UP and BANK
DOWN to select the memory bank (1-30)
where the desired scene is stored.
3
Keep the button AUTO/DEL pressed and
simultaneously select the scene to be
deleted with the buttons SCENE 1-8. To
confirm the deleting procedure, all LEDs of
the controller flash three times.
4
After the desired scene has been deleted,
switch off the programming mode. For this,
keep the button PROGRAM pressed until the
LED next to the button extinguishes.

Deleting All Illumination Scenes

1
Switch off the controller.
2
Keep the two buttons PROGRAM and BANK
DOWN pressed simultaneously and switch
on the controller.
3
After 2 seconds, all LEDs of the controller
flash three times to confirm the deleting
procedure.

Copying Device Settings

All DMX values assigned to a light effect unit can
be conveniently copied to another unit.
1
Keep the SCANNER button pressed of the
unit to be copied.
2
In addition, press the SCANNER button you
would like to copy the values to.
33/40 00081310.DOCX, Version 1.0