Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. OPERATION
Switch on the unit with the rear power switch.
Unlocking Program Mode
Before you can start programming you need to unlock the program mode.
Press and hold the RECORD button.
Press the FLASH buttons 1, 6, 6, 8 of Preset A.
Release the RECORD button.
The red LED above the RECORD button lights up and the program mode is unlocked.
2 x 24 Channel Preset
With the Scene Setter you can adjust two different scenes in Preset A and Preset B and fade from one to
another via the MASTER fader.
Press the MODE SELECT button, until the A DOUBLE/PRESET B LED lights up.
Push Fader MASTER A to maximum.
Push channel faders of PRESET A to the desired setting.
Pull the MASTER B fader to maximum.
Push channel faders of PRESET B to the desired setting.
Fade from Preset B to Preset A by pushing up faders MASTER A and MASTER B.
In Double Preset mode, the buttons over the master faders can be used as flash buttons.
Switching the Dimmer Display
The dimmer display can be switched from percent to the DMX value.
Press and hold the RECORD button.
Press the INSERT button and the display switched to the DMX value (0-255).
In order to switch the display back to percent, repeat the procedure.
Memorizing Scenes
With the Scene Setter you can memorize up to 96 different scenes with 48 channels (Page 1 to Page 4).
Press the MODE SELECT button, until the 1-48 SINGLE/PRESET PARK LED lights up.
Push the fader MASTER A to maximum.
Push channel faders to the desired setting.
Press the RECORD button.
Press and hold the RECORD button and press the desired FLASH button of PRESET B.
The scene is now memorized on this fader.
Calling Up Scenes
Press the MODE SELECT button, until the CHASE/SCENES LED lights up.
Pull all channel faders to minimum.
Push the fader MASTER A and the FADE TIME fader to maximum.
Push the channel fader of the desired scene in PRESET B to maximum.
The scene will be called up.
23/28
00079614.DOCX, Version 1.7
Werbung
Inhaltsverzeichnis
