Setup; Installation; Sound-Control; Connection With The Dimmerpacks - EuroLite Scene Setter Bedienungsanleitung

5) DMX output socket
6) DMX POLARITY selector
7) AUDIO IN socket
8) REMOTE socket

5. SETUP

5.1 Installation

Install the device on a plane surface or install it in a rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

5.2 Sound-control

Via the sound-control, you can run the chasers sound-controlled.
Please note: The controller comes without pre-programmed chasers. These must first be programmed by
the user.
The sound-control works via built-in microphone or via the Line In-socket. Connect the sound-signal from the
mixer (e.g. Master 2) with the RCA-socket on the rear panel (input sensitivity 0.1 V - 1 V).
If a plug is connected with the Line In-socket, the internal microphone is switched off.

5.3 Connection with the dimmerpacks

DMX-512:
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Building a serial DMX-chain:
Connect the DMX-output of the SCENE SETTER with the DMX-input of the nearest dimmerpack. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

6. OPERATION

After you connected the device to the mains, the DMX Scene Setter is ready for use.

Unlock program mode

Before you can start programming you need to unlock the program mode.
Press and hold the Record-button.
Press the Flash-buttons 1, 5, 6, 8 in Preset A.
Release the Record-button.
22/28 00020580.DOC, Version 1.5