Operation; Adjusting A Scene; Setting The Control Channels To The Maximum Value; Setting The Control Channels To Zero - EuroLite FD-512 Bedienungsanleitung

6. OPERATION

Switch on the unit with the rear power switch. The display shortly indicates "DMX512 CONTROLLER". Then
it shows the control channel group in the upper line and the current control channel with its output value in
the lower line. After switching on, always the scene form the internal memory is called.

Adjusting a Scene

1
The 512 DMX control channels of the unit are combine din 64 groups (channel pages) of 8 channels
each (1-8, 9-16, 17-24 etc. up to 505-512). Use the buttons PAGE UP and PAGE DOWN to select the
group of control channels to be adjusted. The display indicates the activated group.
Examples: For control of channels 1-8, select the first group (indication Address=[01]); for channels 9-
16, select the second group (indication Address=[02]).
2
The make the desired adjustments with the channel faders. As soon as a fader is moved, the display
indicates the number of the control channel in the lower line and the current output value as a DMX
value.

Setting the Control Channels to the Maximum Value

1
A short actuation of the button FLASH sets all control channels to the maximum value 255
simultaneously for a short time. The green LED above the button starts flashing as a check. The
position of the channel faders has no effect during this process. Thus, e.g. all DMX fixtures can be set
to maximum brightness for a short time.
By pressing the button once again, the flash function is switched off. The LED will be extinguished and
all channels return to their previous output values.
2
The flash duration can be adjusted. For this, keep the button FLASH pressed until the display indicates
"Set: Flash Time"(control LED lights). Use the buttons PAGE UP and PAGE DOWN to set a duration
between 0.1 seconds and 10 minutes. The display indicates the current adjustment in the lower line. To
exit the setting mode, keep pressing the button FLASH again until the control LED extinguishes.

Setting the Control Channels to Zero

Shortly press the buttons PAGE UP and PAGE DOWN simultaneously to set all control channels to the value
zero. The display indicates "CLEARED".
==DMX512==
CONTROLLER
Set page:
Address=[01]
Page02=CH009-016
16-200
Set Flash Time
[04:30.3]
CLEARED
15/16
Page01=CH001-008
001-030
00081147.DOCX, Version 1.0