Outputs; Operation; Stand-Alone Mode - EuroLite LED PSU-24V/4 DC Bedienungsanleitung

Outputs

The output sockets are located on the side panel. Connect your loads via the output sockets. The controller
is suitable for four LED light tubes:
- 51928790 EUROLITE LED Pixel Tube 360° clear 1 m,
- 51928792 EUROLITE LED Pixel Tube 360° clear 0.5 m or
- 51928793 EUROLITE LED Pixel Tube 360° clear 1.5 m.

OPERATION

After connecting the device to the mains, it starts running. Switch it on with the power switch. This unit has
two operating modes: it can be run as a stand-alone unit without external control or via a DMX controller.

Stand-alone mode

In the stand-alone mode, the LED PSU-24V DC can be used without DMX controller.
Browse through the menu by pressing Mode. Press the Setup button in order to select the desired submenu.
You can change the selection by pressing Up or Down. You can leave every mode by pressing the Mode
button.
Dimmer Mode
Here you can manually select the desired static color and its intensity.
Sound-active Mode
Here you can select from 24 internal programs.
Auto-run program Mode
Here you can select from 24 internal switching color and 24 fading color programs and also set the program
speed.
Static Color Select Mode
Here you can manually select the desired static color and strobe effect.
Other program select Mode
Here you can select the desired display on the control board, set the device to default, as well as select the
desired LED light tube you wish to control:
- tube type 0.5 m
- tube type 1 m
- tube type 1.5 m
24/31 00077886.DOC, Version 1.1