Preparing the Telephone for Use as Wall-mounted Unit
Requirements
–
Tools: small screw driver (approx. 4 mm wide)
Insert the screw driver into the slot at the lower edge of the receiver recess
1.
(see
Fig. 11: Inserting a screwdriver
Push the insert cautiously upward to remove it.
2.
Turn the insert.
3.
Install the insert so that the hook points upward.
4.
Tilt the insert slightly forward with your finger.
5.
Press the insert down until it clicks into place.
6.
COMfortel 600 - Setup and Operation Guide V03 01/2016
Fig.
11).
Preparation
47