Cause And Action; Disposal Of The Old Device - CASO DESIGN VC250 Original Bedienungsanleitung

18.2 Cause and Action

The table below helps to locate and resolve minor faults.
Error
Vacuum unit is not
functioning
The first weld on the
cut off piece of the roll
is not being carried
out.
A complete vacuum is
not being created in
the bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

19 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials. However,
they also contain damaging substances, which were necessary for their functionality and
safety.
Possible cause
Power plug is not plugged in
Defective power cable or plug
Defective electrical socket
Roll is not positioned correctly
The open end of the bag is not
completely inside the vacuum
chamber
The bag is defective
There is dirt on the welding and
the normal seals
The welding bar is overheating so
that the bag melts
The bag is defective
There are leaks along the welding
seam as a result of creases,
crumbs, grease or liquids.
Rectification
Plug in mains plug!
Send device to Customer
Service
Select another electrical
socket
Follow the steps in the
chapter "Vacuum packaging
in a bag originating on the
roll"
Position the bag correctly
Select another bag
Clean the seals and retry
correctly once they are dry
Open the cover on the unit
and let it cool down for a few
minutes
Select another bag; wrap
paper serviettes around any
sharp edges on the content
Open the bag again and
clean the upper internal part
of the bag and remove any
foreign matter that might be
on the welding bar before
you weld the bag shut again.
43