Dmx-Controlled Operation; Addressing - EuroLite LED TMH-75 Bedienungsanleitung

DMX-controlled operation

You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-75 Hybrid will respond to the controller.
If you set, for example, the address to channel 22, the device will use the channel 22 to 42 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-75 Hybrid
correctly and independently from any other fixture on the DMX-chain.
If several LED TMH-75 Hybrid are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-75 Hybrid via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the DMX indicator to the right of the display will be flashing. If there is no data received at the
DMX-input, the DMX indicator does not light up.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Ω
Caution: At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120 resistor
between Signal (–) and Signal (+) in the DMX-output of the last fixture.
28/36 00124762, Version 1.0