Operation - Cameo ZENIT Z180 G2 Bedienungsanleitung

TOUCH-SENSITIVE CONTROL FIELDS WITH BACKLIGHTING
6
MODE
Access the selection menu for system settings by pressing MODE. Pressing it again will return you to the main menu.
ENTER
Pressing ENTER will take you to the menu level in order to apply value changes and to reach one of the submenus. You can also confirm
value adjustments by pressing ENTER.
UP and DOWN
Selects the individual menu options in the selection menu (DMX address, operating mode, etc.) and in the submenus. Allow you to change
the value of a menu option, such as the DMX address, as desired.
7 PRESSURE EQUALIZATION ELEMENT
Pressure equalization element to avoid the buildup of condensation within the housing. Protect this element from contamination in order to
ensure that it functions properly.
8 SAFETY EYEBOLT
When installing in an overhead location, secure the device using a suitable safety cable on the safety eyebolt.
HOUSING FAN
9
The IP65 housing fan is located in the cooling unit between the controller unit and the unit with LED, zoom, and lens. Do not cover the
machine and keep the ventilation slats free of contaminants in order to ensure that the fan functions properly and that air can circulate freely.
NOTE: In order to ensure that the DMX sockets are protected from spray water in accordance with the IP65 protection class,
the special DMX input and output sockets must be correctly sealed with the special IP65 XLR plug or capped with the rubber sealing cap.
When connected correctly, the POWER IN and POWER OUT sockets will protect against spray water in accordance with IP65, as will the
rubber sealing cap.

OPERATION

NOTES
• As soon as the spotlight is correctly connected to the power mains, "Update Wait..." (only for servicing purposes), "Welcome to Cameo",
the model designation, and then the software version are displayed in sequence on the display as part of the startup process. The zoom
unit will also initialize during startup. Once the process is complete, the spotlight is ready for use and resumes whichever mode was most
recently set.
• If one of the DMX modes is active, and there is no DMX signal at the DMX input, the display will begin to blink after a few seconds.
• After approx. 30 seconds of inactivity, the display will automatically show the currently active operating mode (main display).
• Fast Access feature: In order to make navigating the menu simpler, the device has an intelligent menu structure that makes it possible
to directly access menu and submenu options that were previously selected. 1. Pressing MODE and ENTER at the same time will take you
directly to the submenu option that was last modified, where you can immediately change the value as desired (DMX start address and all
operating modes). 2. Pressing MODE will take you directly to the menu option that was last selected and modified.
• Before changing device settings, make sure that the control unit is dry and dust-free in order to ensure that it is functioning properly.
• The display can be rotated by 180° by pressing UP when the main screen is shown on the display.
6
9