System Information (System Information) - Cameo ZENIT Z180 G2 Bedienungsanleitung

PWM Frequency = LED PWM frequency
Fan = Sets fan control
Zoom Range Sets the zoom range
Autolock = Automatically locks the control
element
Calibration = Color and zoom calibration
Zoom Reset = Initialize zoom unit
Factory Reset = Reset to factory settings
Dimmer Curves

SYSTEM INFORMATION (SYSTEM INFORMATION)

Access the selection menu by pressing MODE. Using the UP and DOWN control keys, now select the "System Information" menu option
(note arrow) and confirm via ENTER.
---------------- Menu ----------------
DMX address
DMX mode
Stand Alone
Slave
Settings
 System Information
You can now select the desired submenu option via the UP and DOWN keys, and display the corresponding information by pressing ENTER.
System Information (bold = factory setting)
Firmware =
Temperature =
Operation hours =
800Hz / 1200Hz /
2000Hz / 3600Hz /
12kHz / 25kHz
Auto
Silent
Standard
Extended
On
Off
Red, Green, Blue,
White, Zoom
Reset?
Reset?
linear
DMX value
Displays the device firmware
Displays temperature of LED unit
Displays operating hours
Sets the LED PWM frequency
Automatic fan control
Extra quiet fan with reduced brightness, if required
Standard zoom range
Extended zoom range
Automatically locks the control element after
approx. 30 seconds of inactivity. Shown on display:
"LOCKED"
Lock: Press UP and DOWN at the same time for
approx. 5 seconds
Deactivates automatic locking of the control element
Individual calibration. Cross-mode configuration of R,
G, B, W, and Zoom with values from 000 - 255
Initialize zoom unit:
confirm with ENTER,
cancel with MODE
Reset to factory settings:
confirm with ENTER,
cancel with MODE
exponential logarithmic
DMX value
DMX value
Main CPU Vx.xx
LED LED TEMP xxxC / xxxF
Celsius/Fahrenheit Unit Celsius (= displays in degrees
Celsius)
Unit Fahrenheit (= displays in degrees
Fahrenheit)
OpTime xxxx:xxh Displays the total operating time in
hours and minutes
S-curve
DMX value
11