Herunterladen Inhalt Inhalt Diese Seite drucken

Fora Diamond MINI Bedienungsanleitung Seite 8

Blutzucker-überwachungsssystem
Vorschau ausblenden Andere Handbücher für Diamond MINI:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
after a meal, after taking insulin, or during or after exercise).
We strongly recommend that you perform AST ONLY at the
following times:
• During a pre-meal or fasting state (more than 2 hours since
the last meal).
• Two hours or more after taking insulin.
• Two hours or more after exercise.
Do NOT rely on test results at an alternative sampling site,
but use samples taken from the fingertip, if any of the
following applies:
• You think your blood sugar is low.
• You are not aware of symptoms when you become
hypoglycemic.
• The results do not agree with the way you feel.
• After a meal.
• After exercise.
• During illness.
• During times of stress.
To obtain a blood sample from the alternative sites, please
rub the puncture site for approximately 20 seconds.
1. Replace the lancing device cap with the clear cap.
2. Pull the cocking control out until the orange bar appears
on the release button window.
1
2
Important!
• Do not use results from alternative site samples to calibrate
continuous glucose monitoring systems (CGMS), or for
insulin dose calculations.
• Choose a different spot each time you test. Repeated
punctures at the same spot may cause soreness and
calluses.
• Avoid lancing the areas with obvious veins to avoid
excessive bleeding.
• It is recommended to discard the first drop of blood as it
might contain tissue fluid, which may affect the test result.
Make Blood Glucose Test
1. Insert the test strip into the test slot of the device. Wait for
the device to display the blood drop " ".
2. Select the appropriate measuring mode by pressing MAIN.
• General Tests - any time of day without regard to time
since the last meal.
• AC (
) - no food intake for at least 8 hours.
• PC (
) - 2 hours after a meal.
• QC (
) - testing with control solution.
3. Obtain a blood sample.
Use the pre-set lancing device to puncture your desired
site. After penetration, discard the first drop of blood with a
clean tissue or cotton. Gently squeeze the punctured area
to obtain another drop of blood. Be careful NOT to smear
the blood sample. The volume of blood sample must be at
least 0.5 microliter (μL) for blood glucose testing.
EN-6

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis