Connection Cable Installation - Magnescale SR67A-AZ Serie Bedienungsanleitung

3-3. Connection Cable Installation

• Connect the connection cable to the left or right of the scale head, selecting left or right depending on
the installation location.
• A water-proof cap is fi tted to both ends of the scale head. Remove the water-proof cap from the end where
the cable is to be connected and connect the cable. (Water-proof cap hex. socket-head opposite side 5 mm)
• Use a tightening torque of 1.0 N·m for the connector that is used for the connection with the scale head.
• Apply a thread-locking agent to the threaded area of the connector used for connection in order to
prevent looseness. (Loctite 242 or equivalent)
Notes
Do not remove the water-proof cap from the end that is not connected. If the cap comes off , re-install it
securely. Using the scale unit without the cap may result in damage to the scale head.
Thread-locking agent
Tightening torque:
1.0 N·m
Notes
When the connector has been connected with a torque of 1.0 N·m, check to see that the O-ring of the
connector is correctly placed inside the scale head as indicated below.
SR67A-AZ Series
Connector
SR67A-AZ Series, CH22 Series
2
3
1
Water-proof cap
Connector
Scale head
Scale head
O-ring
Connector
Scale head
11
(E)