Installation; Names Of Parts; Installing The Scale Unit - Magnescale SR67A-AZ Serie Bedienungsanleitung

3. Installation

For the installation dimensions, refer to section 8, "Dimensional Diagrams."

3-1. Names of Parts

Scale unit
End cover
Scale set
Ter inal A

3-2. Installing the Scale Unit

Notes
• Do not turn on the power before installing the scale unit.
• Do not take off the head holders, if possible, until immediately before securing the scale head.
Even if the head holders are removed, the approximate positional relationship of the scale and scale
head will be maintained.
• Th e scale head will be damaged if the scale head is moved outside the eff ective length (L). Th e scale head
must always be moved within the eff ective length.
• Install the scale unit so that the scale is on the upper side of the scale head.
If the upper side is not available, set it to face horizontally. (Fig. 3-2)
6
(E)
Mounting hole M6
Water-proof cap
Scale head
Mounting hole M4 or M6
Head holder
2
Head holder
Fig. 3-1
Scale Scale head
Scale
Scale head
Fig. 3-2
Scale
CH22
Connector cable
1
Scale head
Scale
End cover
SR67A
Ter inal B
SR67A-AZ Series, CH22 Series