3. Bring the scale into contact with the stop surfaces and install.
Example 2: Installation when a stop surface of the scale and the scale head is not made with the
bracket.
1. Adjust the parallelism of the scale bracket and scale head bracket with respect to the machine guide,
and then secure in place.
Adjust the height and parallelism of the scale head bracket with respect to the scale bracket, and then
secure in place.
Scale head bracket
SR67A-AZ Series, CH22 Series
Fig. 3-7
0.05 MG
0.05 MG
Fig. 3-8
78
±0.3
Scale head bracket
Scale bracket
78
±0.3
Unit: mm
9
(E)