Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.15. LOG Clear Function
The "Log clear" function allows you to quickly clear all logged
data points. This function can only be used when the unit is in
LOG mode. It can be used when the user has any number of
LOG locations stored.
You should only use the LOG clear function, if you want to clear
all the log location data that is stored in the unit's memory. The
"LOG clear" function works as follows:
*
While in LOG mode, press the trigger, and then press the
▼-button until you reach LOG location "0".
Note: This can only be done when trigger is pulled. LOG
location "0" cannot be accessed, by using the▲-
button.
When LOG location "0" is shown in the display, press the
*
LASER/BACKLIGHT-button. A tone will sound and the LOG
location will automatically change to "1", signifying that all
data locations have been cleared.
4. Measurement Considerations
Holding the meter by its handle, point the IR sensor toward the
object whose temperature is to be measured.
The
meter
deviations from ambient temperature. Keep in mind that it will
take up to 30 minutes to adjust to wide ambient temperature
changes. When low temperatures are to be measured followed
by high temperature measurements some time (several minutes)
is required after the low (and before the high) temperature
measurements are made.
automatically
compensates
-40-
for
temperature
Werbung
Inhaltsverzeichnis
