Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.3. MODE Button Function
The infrared thermometer provides measurements of Maximum
(MAX), Minimum (MIN), Differential (DIF), and Average (AVG)
Temp. Additional it is equipped with an internal memory. Each
time take a reading. This data is stored and can be recalled with
the MODE-button until a new measurement is taken. When the
trigger is pulled again, the unit will begin measuring in the last
mode selected.
Pressing the MODE-button also allows you to access the High
Alarm (HAL), Low Alarm (LAL), Emissivity (EMS), Each time you
press MODE, you advance through the mode cycle.
Pressing the MODE-button also allows you to access the Type k
Temp. Measurement
The diagram shows the sequence of functions in the MODE
cycle.
3.3.1.Functional Design
*
In the measuring time, pressing MODE button to display
MAX value, MIN value, DIF value, AVG value, LOG value.
*
In the measuring time, if the TYPE-K thermocouple is not
connected, you can adjust EMS by pressing ▲/▼ button.
In the HOLD mode, you can adjust °C/°F by pressing ▲ and
*
▼-buttons at any state.
*
To set values for the High Alarm (HAL), Low Alarm (LAL)
and Emissivity (EMS), press the "MODE" button to adjust the
desired values
-35-
Werbung
Inhaltsverzeichnis
