How To Clean The Air Filter; Disposal Requirements - Panasonic Urban Multi S-20YM3HPQ Installations- Und Bedienungsanleitung

How to clean the air filter
Clean the air filter when the display shows "
CLEAN AIR FILTER).
Increase the frequency of cleaning if the unit is installed in a room
where the air is extremely contaminated.
(As a yardstick for yourself, consider cleaning the filter once a half
year.)
If dirt becomes impossible to clean, change the air filter. (Air filter for
exchange is optional.)
1. Open the suction grill.
Push both knobs simultaneously and carefully lower the grille.
(Identical procedure for closing.) (See figure 26)
2. Remove the air filters.
Pull the hook of the air filter out diagonally downward and
remove the filter. (See figure 27)
3. Clean the air filter.
Use a vacuum cleaner or wash the air filter with water.
When the air filter is very dirty, use a soft brush and neutral
detergent.
Remove water and dry in the shade.
4. Fix the air filter.
Attach the air filter to the suction grill by hanging it to the
projected portion above the suction grill.
Press the bottom of the air filter against the projections on the
bottom of the grille to snap the air filter into its place. (See
figure 28)
5. Shut the air inlet grill.
Refer to item No. 1.
6. After turning power on, press the FILTER SIGN RESET button.
The "TIME TO CLEAN AIR FILTER" display disappears.
(For details, refer to the operation manual of the outdoor unit.)
NOTE Do not remove the air filter except when cleaning.
Unnecessary handling may damage the filter.
Installation and operation manual
9
Downloaded from www.Manualslib.com
" (TIME TO
manuals search engine
How to clean the air outlet and outside panels
Clean with a soft cloth.
When it is difficult to remove stains, use water or neutral
detergent.
When the blade is extremely contaminated, remove it as below
and clean it.
NOTE Do not use gasoline, benzene, thinner, polishing
powder nor liquid insecticide. It may cause
discolouring or warping.
Do not let the indoor unit get wet. It may cause
electric shock or fire.
How to clean the suction grill
1. Open the suction grill.
Push both knobs simultaneously and carefully lower the grille.
(Identical procedure for closing.) (See figure 26)
2. Detach the suction grill.
Open the suction grill 45 degrees and lift it upward. (See figure 29)
3. Detach the air filter.
See the figure in item No. 2 in chapter "How to clean the air
filter" on page 9.
4. Clean the suction grill.
Wash it with a soft brush and neutral
detergent, and dry thoroughly.
NOTE When the suction grill is very dirty, use a typical
kitchen cleaner and let it sit for about 10 minutes.
Than, wash it with water.
5. Fix the air filter.
See the figure in item No. 4 in chapter "How to clean the air
filter" on page 9.
6. Re-attach the suction grill.
See item n° 2.
7. Close the suction grill.
See item n° 1.

Disposal requirements

Dismantling of the unit, treatment of the refrigerant, of oil and of other
parts must be done in accordance with relevant local and national
legislation.
Your air conditioning product is marked with this symbol.
This means that electrical and electronic products shall
not be mixed with unsorted household waste.
Do not try to dismantle the system yourself: the dismantling of the air
conditioning system, treatment of the refrigerant, of oil and of other
parts must be done by a qualified installer in accordance with
relevant local and national legislation.
Air conditioners must be treated at a specialized treatment facility for
re-use, recycling and recovery. By ensuring this product is disposed
of correctly, you will help to prevent potential negative consequences
for the environment and human health. Please contact the installer or
local authority for more information.
Batteries must be removed from the remote controller and disposed
of separately in accordance with relevant local and national
legislation.
S-20~50YM3HPQ
Urban Multi air conditioner
4PW18607-1A