How To Test Run The Air Conditioner - Panasonic CS-ME7NKE-Y Installationsanleitungen

4. How to Test Run the Air Conditioner

� For indoor unit types
After turning on the power of the air conditioner, use the remote
controller and follow the steps below to conduct the test run.
(1) Set the remote controller in Test Run mode. (Fig. 59a)
a)Press and hold the QUIET button and the 1HR. TIMER button.
object such as the tip of a pen. After 5 seconds, release the
c) Then release the QUIET and 1HR. TIMER buttons.
d) appears and "oP-1" blinking in the remote controller clock
display area. (Fig. 59b)
(2) Start Cooling mode test run by pressing the ON/OFF operation
button of the remote controller. (Fig. 59a)
cator lamps (OPERATION lamp, TIMER lamp, and
main unit blinking. (Fig. 59c)
cool air will start to be felt. Cooling mode test run is unaffected
by the room temperature.
(3) Press the ON/OFF operation button of the remote controller again
to stop the test run. (Fig. 59a)
release it from Test Run mode to return to normal mode.
(Fig. 59a)
display area.
IMPORTANT
button to return to normal mode. The air conditioner will not operate
correctly if this is not done.
QUIET
button
) on the
17
ON/OFF
operation
button
1HR.
TIMER
button
ACL
(Reset)
button
Fig. 59a
Fig. 59b
TIMER lamp
OPERATION lamp
Fig. 59c