PeakTech 2170 Bedienungsanleitung Seite 62

Note:
1. When Auto-LCR mode is active, the secondary parameter
2. In order to avoid damaging the instrument, the capacitance
8.3. Resistance measurement
1. Turn on the power.
2. Insert the measured resistance into the input terminal
3. Connect the alligator clips to the ends of the measured
4. The default test mode is Auto LCR mode, the resistance
5. Press FUNC.-key three times to select Auto-R (ACR)
6. Press
7. Press SER/PAL key to select series or parallel mode.
8. Press FUNC. key four times to select DCR mode. The
Downloaded from www.Manualslib.com
will show the equivalent resistance in parallel mode (Rp) to
replace the D factor if the C measured value is less than
5pF.
requires discharge before measuring.
directly.
resistance.
value will show on primary display and the phase angle θ
will be shown on secondary display. In Auto LCR mode,
the D/Q/ESR key, SEL/PAL key, SORTING key and
REL% key are not available.
mode. The primary LCD display will show the resistance
value. The secondary parameter is omitted and the
D/Q/ESR key is not available.
FREQ
100/120Hz/1/10/100 kHz.
primary LCD display will show the resistance value. The
secondary parameter is omitted and the D/Q/ESR key,
SEL/PAL key and FREQ key are not available.
manuals search engine
key to select
-61-
frequency value: