PeakTech 2170 Bedienungsanleitung Seite 56

6. In short calibration mode, the secondary display will show
7. When using square terminals, insert the short socket to the
8. When using L
9. Press CAL key and the 30-second countdown will be
Note:
1. To get the better accuracy, the open/short calibration
2. The purpose of open/short calibration is to reduce the
3. Open or short circuit is selected automatically according to
4. In short calibration, there may be FAIL situations, which
Downloaded from www.Manualslib.com
"Short". There are two ways for short state input:
square terminals and make L
hang in the air
/L
CUR
and red testing lines with alligator clip into the "L
"L " terminal and "H
POT
Connect the mouth of clips.
shown on LCD panels. If the short calibration is finished,
the PASS or FAIL symbol will appear on the primary
display. Press CAL key again to save the calibration data.
should be done before measurement.
parasitic effect of the test fixture.
the measurement terminal.
may be caused by not using the low resistance short line
or unreliable contact, please try again after reliable short-
circuit
manuals search engine
/L
CUR POT
/H /H terminals, insert the black
POT POT CUR
", "H " terminal respectively.
CUR POT
-55-
/H /H terminals
POT CUR
CUR
",