PeakTech 2170 Bedienungsanleitung Seite 61

8.2. Capacitance measurement
WARNING:
If there exist voltage in the capacitor (charged), connect the
two ends of the capacitor for a short time to discharge.
Otherwise, the device can be damaged through overvoltage.
1. Turn on the power.
2. Insert the positive polarity of capacitance into the positive
3. Insert the black and red testing lines with alligator clip into
4. The default test mode is Auto LCR mode, the capacitance
5. Press FUNC.- key twice to select Auto-C mode. The
6. Press FREQ key to select frequency value: 100/120
7. Press SER/PAL key to select series or parallel mode.
Downloaded from www.Manualslib.com
terminal and its negative polarity into the negative terminal.
the "L ", "L
CUR POT
respectively. Connect the alligator clips to the two ends of
capacitance corresponding to its polarity.
value will be shown on primary display and the dissipation
factor D will be shown on secondary display. In Auto LCR
mode, the D/Q/ESR key, SEL/PAL key, SORTING key and
REL% key are not available.
primary LCD display will show the capacitance value. The
secondary LCD display will show the dissipation factor D.
The quality factor Q, equivalent resistance ESR/Rp or
phase angle θ can also be shown by pressing the
D/Q/ESR key.
Hz/1/10/100 kHz.
manuals search engine
" terminal and "H
-60-
", "H " terminal
CUR POT